|
|
Circuits > Audio > Stereo Tone Control
Stereo Tone Control
This simple tone control can be used in may audio applications.
It can be added to amplifers, used as a stand alone control module, or even built
into new and exciting instruments. It's one IC construction makes it a very compact
circuit, as only a few support components are required. Plus, it does not use a
dual power supply. This means that the circuit will run from VCC = 9V to 15V (although
the bass will be a little weak at 9V).
S1 is a contour control. Volume is controlled by P1. Balance
is controlled by P2. P3 and P4 control bass and treble, respectivly. J1 is the left
input, J2 is the right input. J3 is the left output, J4 is the right output. The
circuit is designed to accept line level or mic level inputs. if you are going to
be using a stronger signal, a voltage divider will be necessary to cut it down to
proper levels. You can, of course, skip J1-J4 if you plan to integrate this circuit
into another.
Title: Stereo Tone Control
Source: unknown
Published on: 2005-08-27
Reads: 1899
Print version: 
Circuits > Audio > Stereo Tone Control |
|
